Hi, How do I connect all modules together with the mini din?
Do every module need separate power?
4-ROOM-USB
Moderator: marcus
3 posts
• Page 1 of 1
Re: 4-ROOM-USB
by IRTrans » Wed 4. Feb 2009, 15:25
Hi,
in general the Pins 1 (GND), 2 (operating voltage) and 3 (Data) need to be connected. There is a picture in the manual showing the PIN Configuration.
In addition we do have short bus cables available. When using these cables only the 3 color coded cables need to be connected to your installation.
When you use this 3 lines only one of the IRTrans devices needs a power supply. If you only have 2 lines (GND / Data) each IRTrans device needs a power supply.
IRTrans
in general the Pins 1 (GND), 2 (operating voltage) and 3 (Data) need to be connected. There is a picture in the manual showing the PIN Configuration.
In addition we do have short bus cables available. When using these cables only the 3 color coded cables need to be connected to your installation.
When you use this 3 lines only one of the IRTrans devices needs a power supply. If you only have 2 lines (GND / Data) each IRTrans device needs a power supply.
IRTrans
- IRTrans
- Administrator
- Posts: 2115
- Joined: Mon 21. Apr 2008, 23:32
Re: 4-ROOM-USB
by tonlof » Wed 4. Feb 2009, 16:43
Okey thanks, so i don't need any resistors on data line. Just connect all the data to same cable.
/Tony
/Tony
- tonlof
- Posts: 5
- Joined: Wed 4. Feb 2009, 14:57
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests