0. The firmware version is 6.03.25
1.The STB is connected with the IR OUT 1, the IRTrans USB(as a receiver) is connected with IR OUT3 and all the other IR OUT are empty.
2. "internal LEDs active and external LEDs active" are set, the external LEDs active must be set, or the IRTrans USB has no response and only the STB has response.
3. The .rem file is attached.
4. I send the command "irclient 10.85.7.118 skyremote 0 0 0"
5. Both the STB and IRTrans USB have responses.
6. I send the command "irclient 10.85.7.118 skyremote 0 0 1"
7. None of the STB and IRTrans USB has response.
8. I send the command "irclient 10.85.7.118 skyremote 0 0 2"
9. Both the STB and IRTrans USB have responses.
Do you think that is right? And how can I control the devices separately??
I think it correct that only one device(IR OUT 1 or IR OUT 2) has response, is that right???
I find that <sendmask> is Sendmask on the serial bus(0 selects all devices), what are the all devices? LED 1- LED 8???
<bus> bus number(0=1st device...) what is bus???
<led> LED selection(i=internal, e=external, 1-8=LED number) what is the relation between this and the setting above(internal LEDs active, external LEDS active)?? I think that 1-8 are the IR OUT 1-8, right??