Page 1 of 1

send commands when multiple IR recieved

PostPosted: Tue 14. Oct 2014, 12:54
by davidlefevre
Hi,

I am using LAN I/O
I would like to know if it is possible to send an ethernet command after recieving more than 1 IR command.

Basically, i want to press "1" then "0" on my remote, and a specific command to be sent on Ethernet and RS232 by the IR TRans.
Untill now, i am only able to send a command associated with "1", then a command associated with "0".
I want a command associated with "10", but there is no "10" button on my remote, i have to type a combination of "1" then "0".

thanks !

David

Re: send commands when multiple IR recieved

PostPosted: Wed 15. Oct 2014, 10:20
by eric
Hi David,

unfortunately this is not possible.

best regards,

Eric