IRTrans Support Forum

I'm using irTrans Ethernet module with iRedTouch for controlling media equipment in home and I'm not sure do I have to remove small internal red jumper in irtrans device for using IRT-TRANS-HPK with my module?

Hi,
the small red jumper (next to the IR Receiver) is used to disable the internal receiver when an external receiver is connected.

To use the HighPower Transmitter a jumper should be added next to the connector for the external transmitters (near the power connector).

The manual for external transmitters / receivers shows where the jumpers are. You can also download this manual from our website.

IRTrans

Thank You for reply,
I tried to find manual for external transmitters on your web page but was unable to locate it, so if you could please send me link to manual. I only received two printed manuals in my package. - First one is IRTrans users manual and the other is IRTrans ethernet and PoE supplemental users manual. In download section of your web page there are only basic hardware and software manuals but none for external transmitter.

You are right, sorry.

Please send us an Email, we will then send you the Transmitter manual.

IRTrans

Please send transmitter manual to mladen.k@imkolbis.com. Thank You!

Please, I haven't yet received transmitter manual. Please send it to above mentioned e-mail address.

Sent ...