LanController XL stopped working.

[agbnielsen]

Hi,

I have a IRTrans ethernet V1.2 on the network.
It was working fine last week now all of a sudden it doesn't seem to relay commands for all my devices.
The LED on the modules do not flash.

Thanks

[IRTrans]

Hi,
please check all the device settings.

Can you reach the device via ping ? Can you access the HTML config pages ?

It would be important to see the settings for IR Relay (HTML interface).

IRTrans

[agbnielsen]

Hi,
I Can connect to IRTrans fine. Someone told me that the signal from the outputs were too strong causing interferance with the other devices.

Now I have a new problem.
The physical remote controls works perfectly fine, but when the commands are send from one of the logical remote it repeats; the other logical remote is fine. Only one does the repeating when commands are sent.
I have no idea what could be causing it. I've turned off the "Repeat mode", "Self repeat" and Repeat via internal LEDs"

Thanks

[IRTrans]

You mean that relaying does not work correctly for one remote control ?

Relaying is a rather difficult thing. It will only work if the codes from the original remote can be received in perfect quality all the time.

If you have a remote control using a non standard carrier frequency relaying will not work.

IRTrans