Page 1 of 1

IR TRANSLATOR V 2.0 does not translate

PostPosted: Sun 7. Mar 2010, 20:47
by alfiomantiineo
Hi

I own a IR Translator V2.0
It was not used for some time, now I was trying to use it to translate the Bang & Olufsen BEO4 command to an old Dreambox.
The dreambox remote gave me some problems so I used the raw signal.

I tested the correctness of the data acquired using the "send" command of IR TRANS GUI Client and everything worked correctly.

After I flash the translator I get the green led to notify it received the signal but no signal is send to the dreambox.

Any suggestions ?

Re: IR TRANSLATOR V 2.0 does not translate

PostPosted: Mon 8. Mar 2010, 22:35
by IRTrans
It looks like either the Translation table is not correct or you are using the wrong B&O Command.

Please check with "Received IR Commands" if the B&O Commands are detected correctly.

IRTrans