No IRTrans Devices Found (2)

[sanddevil]

Hi! I have similar circumstances to
http://www.irtrans.de/forum/viewtopic.php?f=22&t=92&p=295
but I am using the IR110 device on a Origen X15e chassis

I have a clean Vista Home Premium installation, and Vista has sensed the presence of the IR device and added the drivers. I manually added the latest IRServer software.
When I boot up I get the "IRServer Version 5.12.08 No IRTrans Devices Found" diagnostic.

Looking at the earlier thread, you are suggesting that either (a) my device is broken (I don't think so - I had it working on another media center PC but this was 18 months ago and I can't remember how I succeeded then) (b) it needs a 5v connection.

So, assuming that the board requires a 5v power supply, where do I get that from and where does it go?

Looking at the board, there are 3 connections.

K4 - I have RESET SW 2-pin plug in here
K5 - I have POWER SW 2-pin plug in here
K6 - I have nothing here.

Do I need to plug 5v into K6 or is that already in K5? I have no other connectors available, eitehr from my power supply or the case so I am baffled. I have moved around RESET and POWER and can only get it to power the PC in the combination above.

Any help grateful.

Many thanks in anticipation.

[IRTrans]

Hi,
please contact OrigenAE with that issue.

Normally there should be an adaptor cable provided for +5V standby - however this is just a guess as we do not know this hardware.

IRTrans

[sanddevil]

Hmmm. OrigenAE's support page is "under constructon" and a link to their ticket system for support gets a http 404 response. Fantastic.

[sanddevil]

Hi,
please contact OrigenAE with that issue.

Normally there should be an adaptor cable provided for +5V standby - however this is just a guess as we do not know this hardware.

IRTrans

I owe you a debt of gratitude! Something in that 1 line of yours made me go and find the original box the chassis came in 18 months ago. Inside was a cable I must have used in the first media PC I built. Basically, in case someone asks the same question as me, Origen provide a thick Female/Female 24pin power cable. One end goes into the motherboard, the other into the power supply. Attached to this cable is the 5v standby cable you mentioned.

I have installed it. It works!!!

Many thanks

[jandrews]

can you tell me what cale you are talking about...do you have a pic you can send me

[brookedow]

Deleted