Page 1 of 1
send unlearned ir-commands
Posted:
Sun 28. Mar 2010, 21:32
by fsteding
Hello,
i want to send ir-commands via the .net-api (or directly via udp) which I havend stored before.
Is this possible? I reat all the documentation but I didn't found an concret yes or no.
Kind regards,
Frank
Re: send unlearned ir-commands
Posted:
Mon 29. Mar 2010, 08:26
by IRTrans
Hi,
in general only learned commands can be sent.
Without learning you would not know the command and therefore not know what to send.
IRTrans
Re: send unlearned ir-commands
Posted:
Mon 29. Mar 2010, 12:39
by fsteding
...learning is necessary and okay, but I want to store the commands in my application, not in the irtrans-server.
Is this possible?
Regards,
Frank
Re: send unlearned ir-commands
Posted:
Mon 29. Mar 2010, 16:40
by IRTrans
Hi,
that is not supported with the irserver.
If you have LAN IRDB Devices you can use the TCP Interface for those devices. This interface allows to
store and send IR commands locally.
IRTrans
Re: send unlearned ir-commands
Posted:
Mon 29. Mar 2010, 19:00
by fsteding
That sounds good!
I have such a device. Where can I find the documentation of this protocol?
Regard,
Frank
Re: send unlearned ir-commands
Posted:
Mon 29. Mar 2010, 20:29
by IRTrans
The documentation for the TCP ASCII interface is available for download on our website (Download section).
IRTrans
Thanks
Posted:
Mon 29. Mar 2010, 21:17
by fsteding
Thank you for your quick help!