Here's the deal - I have an Adesso ARC-1100 remote (basically a MCE remote). I have successfully learned all of the buttons on it, and it almost works great! The only problem is that I cannot successfully program repeat codes (if that's the proper term - I want to be able to hold down my Volume Up button and have it continually run the Vol+ command). Currently what happens is that I will press my Volume Up key and it will register only once even though I continually hold down the button. I have tried learning the code using the "Repeat Code" option, but that doesn't seem to register or match at all in the "detected IR commands" window.
Even more, when I press the Volume Up on my remote, it registers 3 different codes (one for a "keydown", one for a "hold" and one for a "keyup") so if I quickly press the Volume Up button, it registers the following:
- Code: Select all
09:12:34 : 4332012100210
09:12:34 : 433021210330
09:12:34 : 43333210330
The first code [4332012100210] being the code that has been learned and matched to the [Vol+] button in my .rem file.
Now if I hold the button down, I get the following:
- Code: Select all
09:12:34 : 4332012100210
09:12:34 : 433021210330
09:12:34 : 433021210330
09:12:34 : 433021210330
09:12:34 : 433021210330
09:12:34 : 433021210330
09:12:34 : 43333210330
The middle code being repeated until I let go of the button.
Now for good measure, I confused myself more by following the previous topic "Different codes for same command?" and changed my Recv Timeout to 90 seconds (I was using 15ms to capture all of these other codes). After changing the Timeout, the codes displayed for pressing the button now were different based on how quick I tap the button, so now when I hit the Volume Up key as quickly as possibly, I get:
- Code: Select all
09:18:28 : 433201210021543302121033543333210330
when I tap it not as quickly I get
- Code: Select all
09:20:11 : 433201210021543302121033543302121033543302121033543302121033543333210330
and then when I hold the button for a extended period I get
- Code: Select all
09:26:56 : 433021210330
09:26:57 : 433021210330
09:26:57 : 433021210330
09:26:57 : 433021210330
Well, clearly, I am lost and don't know what I'm doing - but I've run out of ideas for trying to fool around with stuff until it works. What should my Recv Timeout properly be set to? Have I merely been cropping out sections of the received IR codes by setting the threshold so low at 15ms? How can I properly program my remote for Repeat Codes?
Thanks in advance to any kind soul willing to help, it is greatly appreciated!!!!