HI,
I aquired the lan xl controller and the 3x a irbus module.
I've got 4 wires left over to each room in which a irbus should be placed and the lan XL will be in the central location.
What should be the wiring schematics?
On the XL controller i see the serial bus connector. I assume i need to send out the wire from there 3x towards the irbus module. But i dont know the pin layout off the connector (what needs to be connected with what) the same story goes for the connectors on the irbus modules. I've ordered all the correct jacks/connectors so i am basicly good to go, only need to know which wire goes in where with what pin numbers.
I dont see this information on the website clearly or i am not looking in the right place.
So:
[Irtrans XL] (in basement)
/|\
|| \ _ ir bus module
| \_ ir bus module
\_ ir bus module
Can your clarify these items?
Thanks in advance,
Eric