IRTrans Support Forum

Hello,

I just changed my satelit decoder for a new one, and i can't learn order from the remote. Here is the content of a test file, every command was from the same key of the remote

[REMOTE]
[NAME]test

[TIMING]
[0][N]7[1]192 296[2]336 160[3]184 560[4]352 408[5]256 752[6]344 648[7]336 88648[RC]1[RP]0[FREQ]38

[COMMANDS]
[test1][T]0[D]21621110103110472152241114411111
[test2][T]0[D]  )  * %  7 * * 7 
[test3][T]0[D]  +  +  , ,  (
216230111111
[test4][T]0[D]  +  * 6  . * , &

Xcuse my crap english,
Thanks for any help

Hi,
I suppose the Sat Receiver uses a carrier frequency (e.g. 56kHz) that the IRTrans cannot learn.

To learn such codes you will need an Universal learning receiver.

IRTrans

Hello,

Thanks for your fast response. Can u tell me where i can find this "Universal learning receiver" ?

Sorry for my last question

Finally found/bought from your store a COD-RCV-EXT. I want to use it with a Ethernet module version 2.3

Here are the info from diagnostic :

IRServer Version 6.02.82
[ 0]: IRTrans LAN : IR VER: E6.04.51 ETH VER: L1.07.56 SN: 46047

According to your documentation (Ethernet_EN.pdf Page 3) we have plugged the external receiver in the front of the module.

I have use GUI client to parameter the External receiver, like this :



When i try to learn code, server did'nt recognize any order from remotes, and end with a timeout.

Any help would be appreciated, thanks in advance,

Hi,
in general that setup looks good.

Does the IRTrans react at all (blink green) if you press a remote button ?

You connected the External receiver on the side opposite from the LAN connector ?

Are you sure that you have an external Codelearning receiver ?

Which firmware version does your IRTrans device have ?

IRTrans

Hello,

Does the IRTrans react at all (blink green) if you press a remote button ?
No reaction at all when i press a remote if the Codelearning is pluged

You connected the External receiver on the side opposite from the LAN connector ?
Yes, external receiver is pluged in the front of the module, on the side opposite for the LAN connector and power supply

Are you sure that you have an external Codelearning receiver ?
I hope I've got bought it on your store, ref : COD-RCV-EXT.

Which firmware version does your IRTrans device have ?
It's an Ethernet V2.3, diagnostic from this module is : [ 0]: IRTrans LAN : IR VER: E6.04.51 ETH VER: L1.07.56 SN: 46047.

Thanks for your help, Kana

Hi,
could you please try out the setting "38kHz External".

Then we are sure that you got the correct receiver.

IRTrans

Hello,

When i use 38Hz External the module blink green when i use the remote.

Order learned this way dos'nt work

Thanks

Hum sorry, i have selected 38kHz receiver, not 38kHz receiver ext.

In this case (38kHz EXT) the module dos'nt blink when i send an order with a remote

OK, then it looks like your external learning receiver is defective.

You will need send it to us so that we can check and exchange it.

IRTrans