I'm having problems with an Origenae S16V case setup
I noticed that after installing the motherboard and applying standby power the orange standby light flickers then goes out. On powering up the blue power light comes on and is steady, the system fans work and it boots to the bios logo screen but hangs 90% of the time, no error beeps from the bios. If I disconnect the front panel USB cable from the motherboard header
the orange standby light comes on and is steady. When it does boot and a USB drive is plugged into the front USB socket I get an error message 'USB hub exceeded power requirements'. The vender sent a replacement front panel PCB
I installed it and on switching on the power supply the orange standby light once again flickers then goes out. I switched the system on and it hangs at the Bios logo screen 90% of the time, no error beeps.
I have replaced all the system components with those of my other working system, deferent motherboard, graphic card, processor, ram, hard drive, operating system (windows xp)and power supply. The same problem it hangs 90% of the time at the Bios logo screen.
I disconnected all power to the VFD module and the S16V power switch and wired the motherboard power switch connection to my old case, it boots with no problem, no hanging at all. If I reconnect the s16v power switch only, not the VFD module it boots without hanging at all.
Is it a faulty VFD module or a firmware issue?